Technical Review: AirTAC GFC300C08ALC1WK Air Source Treatment Component - Selection Guide & Specs
يشارك
Overview
The AirTAC GFC300C08ALC1WK air source treatment component addresses the critical industrial challenge of maintaining clean, regulated, and lubricated compressed air systems. This two-piece FRL (Filter-Regulator-Lubricator) unit eliminates common pneumatic system failures caused by contaminated air, pressure fluctuations, and inadequate lubrication, ensuring optimal performance for industrial pneumatic equipment.
Technical Analysis
The GFC300C08ALC1WK represents a comprehensive air preparation solution featuring a metal cup construction, integrated mounting bracket, and reverse flow valve protection. This unit combines three essential functions: filtration to remove contaminants, pressure regulation for consistent operation, and lubrication to extend component lifespan in demanding industrial environments.
| Specification | Value |
|---|---|
| Port Size | 3/8" NPT |
| Maximum Operating Pressure | 1.0 MPa (145 PSI) |
| Pressure Range | 0.15-0.9 MPa (20-130 PSI) |
| Filter Grade | 40 μm |
| Drain Type | Semi-Automatic |
| Construction | Metal Cup with Aluminum Alloy Body |
| Mounting | Integrated Bracket with Table |
| Flow Capacity | 300 L/min (at 0.7 MPa) |
| Reverse Flow Valve | Included for System Protection |
| Operating Temperature | -5°C to 60°C |
Buying Considerations
When selecting the AirTAC GFC300C08ALC1WK for your application, consider these critical factors:
Port Size Matching: Ensure the 3/8" NPT ports match your existing pneumatic fittings and system requirements. Mismatched port sizes can lead to pressure drops and reduced efficiency.
Flow Rate Requirements: With a 300 L/min flow capacity, verify this meets your equipment demands. For higher flow applications, consider larger air treatment components from the GFC series.
Pressure Regulation Needs: The 20-130 PSI operating range suits most industrial applications. For specialized pressure requirements, consult the complete AirTAC product catalog.
Installation Environment: The integrated bracket and table facilitate easy mounting in confined spaces. Consider the unit's orientation and accessibility for maintenance.
Maintenance Schedule: Plan for regular filter element replacement and lubricant refilling based on your operating hours and air quality conditions.
Frequently Asked Questions
Q: What is the recommended maintenance interval for the AirTAC GFC300C08ALC1WK?
A: Under normal operating conditions, inspect the filter element every 3-6 months and replace when pressure drop exceeds 0.1 MPa. The lubricator should be refilled when the oil level drops below the minimum mark.
Q: Can this unit handle aggressive industrial environments?
A: Yes, the metal cup construction and aluminum alloy body provide excellent durability. However, for highly corrosive environments, additional protective measures may be necessary.
Q: What type of lubricant should be used with this system?
A: Use ISO VG32 or equivalent pneumatic tool oil. Avoid using incompatible lubricants that may damage internal components or contaminate the air stream.
